Cassette mate will not connect drivers#
Cassette mate will not connect series#

Alternately, a brand new document can be started and any content that appears in the cutting area can be copied from the original document and copied into the new document. To resolve the concern, remove any additional content that may appear outside of the cutting area and try to cut the job again. The power light flashing indicates that the Silhouette is on standby and will resume cutting after a few moments. This has nothing to do with the processing speed or ability of your computer, but rather the Silhouette machine itself.

The presence of content outside of the cutting area, which is also being processed (even though it is not being cut).

The image intricacy (overall line length and number of points or nodes in the job).

This problem is a large data stream is being sent to the Silhouette machine. This is most common with the Original Silhouette. If the cutting process pauses for prolonged periods of time (up to several minutes at a time) and the power light flashes, your machine is overwhelmed by the amount of data being sent. My Silhouette Pauses for Long Periods of Time During a Cut Job If you power off the Silhouette to stop the job, please note that the job cannot be resumed where it left off. This will abandon the job rather than pause it. The only immediate method to stop a cut job would be to power off the Silhouette completely.

It may seem like the machine is not responding to pressing pause, but it should very quickly. It would then stop and not move to complete further circles.

Cassette mate will not connect series#

For example, if your Silhouette was cutting a series of circles, pressing the Pause button would not stop the cutting action until the Silhouette stopped cutting the circle it was working on when the button was pressed. If pressing вЂњPauseвЂќ does not immediately stop the job, it is because it is waiting to stop the job after it has completed the current continuous line it is working on. My Silhouette DoesnвЂ™t Stop When I Press вЂњPauseвЂќ This will direct the older unitвЂ™s driver, which is no longer present, to stop trying to take up the USB connection and subsequently stop it from confusing your Silhouette machine.

Repeat this action for all applicable printer drivers.

Locate the port type вЂњFileвЂќ and check this box.

In the window that comes up, go to the Ports tab.

Cassette mate will not connect drivers#

Right-click on one of the printer drivers in question and go to the Printer Properties option.Look for any printer drivers that are greyed out or printers which are no longer hooked up to the computer.This indicates that there is another USB device (such as a printer) that is trying to communicate with the Silhouette.Дo the following steps solve this problem: The issue stops if the USB cord is removed, but is repeated without stopping if the unit is powered on and the USB cord is connected to the computer. If when your Silhouette is powered on, it immediately begins to go through cutting motions (starts to cut the same job repeatedly or the blade taps up and down rapidly) prior to you sending a cut job, another device is trying to communicate with your machine. My Machine Starts Cutting When I Turn It On Otherwise, know that the Silhouette is unfortunately not a whisper-quiet unit.

Remove the tape and power the Silhouette unit back on. If this was not previously removed, this would be the cause of the excessive noise. Lift your SilhouetteвЂ™s lid to make sure any tape that is connecting the motor to the side of the unit has been removed.

If your Silhouette makes noise while cutting, it is probably normal. Silhouette Cloud Silhouette Machine My Silhouette Machine Is So Loud!